• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
The knock sensor (KS) is a piezoelectric device that produces an AC voltage of different amplitude and frequency depending on the level of engine mechanical vibration. The KS system monitors the knock sensor in order to determine if detonation or spark knock is present. If the KS system determines that excessive knock is present, the engine control module (ECM) retards the spark timing based on the signal from the KS system. The KS produces an AC signal when specific frequencies are detected. The ECM then retards the timing until knock is controlled.
The ECM tests the functionality of the internal knock sensor signal evaluation circuitry. The KS circuitry within the ECM is responsible for receiving, amplifying, filtering, and evaluating the AC voltage and frequency from the knock sensors. The ECM performs two tests that determine if the internal circuitry within the ECM is functioning correctly.
The ECM internally turns OFF the knock sensor signal circuits. The ECM then applies different test signals to the internal KS circuitry to verify that each test signal output response is within range. If the ECM detects that any of the test signals are not within range, this DTC sets.
The ECM internally turns OFF the knock sensor signal circuits. The ECM then tests for any output response when no test signals are applied. If the ECM detects an output response, this DTC sets.
The ECM internally turns OFF the knock sensor signal circuits. The ECM generates an internal test pulse and monitors the return signal. If the return test pulse is less than a calibrated threshold, this DTC sets.
• | The ECM is controlling spark. |
• | The engine coolant temperature is greater than 60°C (140°F). |
• | DTC P0324 runs continuously once the above conditions are met. |
• | The ECM detects an incorrect response to the self tests performed on the internal KS circuitry. |
• | The condition exists for greater than 1 seconds or for a cumulative of 10 seconds. |
DTCs P0324 is a Type B DTC.
DTCs P0324 is a Type B DTC.
Knock Sensor (KS) System Description
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Control Module References for scan tool information
Note: If you can hear an engine knock, repair the engine mechanical condition before proceeding with this diagnostic.
⇒ | If DTC P0335, P0336, or P0338 is set, refer to DTC P0335, P0336, or P0338 for further diagnosis. |
⇒ | If DTC P0324 failed this ignition, replace the ECM. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for engine control module replacement, setup, and programming