• | 7185 Power Steering Pump Pulley Remover |
• | 7005 Power Steering Pump Pulley Installer |
Caution: Refer to Safety Glasses Caution in the Preface section.
Caution: Refer to Vehicle Lifting Caution in the Preface section.
Important: The half jaws (6) must be fully engaged with the pulley flange (5) and the 7185 flange (1), the larger open end diameter (has chamfer and relief profile) engages with the pulley flange (5).
Important: The forcing screw (7) must be aligned with the pump axis.
Important: Observe the orientation and the depth of the pulley (3) with reference to the original position, this will minimise the potential of incorrect pulley installation.
Important: Do not use power tools or exceed a torque of 90.0 N·m. If the pulley cannot be removed within this torque, remove the pulley using 7185 . If still unsuccessful, replace the complete power steering pump assembly.
Important: Before installing the pulley (4) it must be properly aligned and orientated in relation to the pump shaft (3).
Important: The depth to which the pulley (4) is going to travel must be observed and maintained.
Important: Hold the forcing screw hex (5) while tightening the forcing nut (1).