The shift solenoid (SS) valve 2 is part of the lower control valve body. The SS valve 2 is a normally closed (NC) solenoid valve and controls fluid to the clutch select valve 3- and related clutches. During this diagnostic test, intrusive actions are taken by the transmission control module (TCM) to test the SS valve 2 to see if the valve is stuck OFF. When in first gear engine braking, if first gear ratio is not achieved in a predetermined period of time, the TCM commands second gear and if second gear ratio is attained this indicates a stuck OFF SS valve 2 and the DTC will set.

The TCM detects second gear ratio is achieved.

DTC P0756 is a Type A DTC.

DTC P0756 is a Type A DTC.

When attempting to set transmission performance DTCs, observe the Freeze Frame and Failure Records to assist in duplicating the failure conditions. Ensure the transmission fluid level is correct and there are no leaks.

Schematic Reference

Automatic Transmission Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Special Tools

DT-47825 Control Solenoid Test Plate

1. Perform the Transmission Fluid Check Procedure.
2. Operate the vehicle in drive with the calculated throttle position greater than 15 percent to obtain 56 km/h (35 mph) 2 times.

⇒	If the DTC resets, go to Circuit/System Testing.

1. Perform the Line Pressure Check.

⇒	If the pressure is out of specification correct that concern first.

2. Perform the Control Solenoid Valve and Transmission Control Module Assembly Cleaning and retest the DTC as outlined in the Circuit/System Verification steps.

⇒	If the DTC resets, continue on with testing.

3. Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection.

⇒	If a concern is found, repair or replace the control solenoid (w/body and TCM) valve assembly.

4. Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test.

⇒	If the solenoid is found to be leaking or stuck OFF, replace the control solenoid (w/body and TCM) valve assembly.

Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Replace the control solenoid (w/body and TCM) valve assembly. Refer to Control Module References for replacement, setup, or programming.