GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 41478 Crankshaft Front Oil Seal Installer

    Important: 

       • Do not lubricate the oil seal sealing surface.
       • Do not reuse the crankshaft oil seal.
       • Lubricate the outer edge of the oil seal with clean engine oil.
       • Lubricate the front engine cover oil seal bore with clean engine oil.


    Object Number: 1950874  Size: SH
  1. Install the crankshaft front oil seal onto the J 41478  (3) guide.
  2. Install the J 41478  (3) threaded rod (with nut, washer, guide, and oil seal) into the end of the crankshaft.
  3. Use the J 41478  (3) in order to install the oil seal (2) into the front engine cover (1) bore.
  4. 3.1. Use a wrench and hold the hex on the installer tool.
    3.2. Use a second wrench and rotate the installer nut clockwise until the seal bottoms in the front engine cover (1) bore.
    3.3. Remove the tool.
    3.4. Inspect the oil seal for correct installation. The oil seal should be installed evenly and completely into the front cover bore.