Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC B0052: Deployment CommandDTC B0053: Deployment Commanded With Loop DTCs Present
Circuit/System Description
The inflatable restraint sensing and diagnostic module (SDM) contains a sensing device that converts vehicle velocity changes into an electrical signal. The SDM compares this electrical signal to a value stored in memory. When the generated signal exceeds the stored value, the SDM performs additional signal processing and compares the generated signals to values stored in memory. When 2 of the generated signals exceed the stored values, the SDM will cause current to flow through the deployment loops, deploying the air bags and/or pretensioners causing DTC B0052 or B0053 to set.
Conditions for Running the DTC
Ignition voltage is between 9-16 volts.
Conditions for Setting the DTC
B0052
| • | The SDM detects a frontal impact of sufficient force to warrant deployment of the frontal modules. |
| • | The SDM has deployed the seat belt pretensioner for 3 separate deployments. |
B0053
SDM commands inflators deployment with loop faults present.
Action Taken When the DTC Sets
| • | The SDM requests the instrument panel cluster (IPC) to illuminate the AIR BAG indicator. |
| • | The SDM records crash data. |
Conditions for Clearing the DTC
The DTC can be cleared if the following conditions are met:
| • | Three consecutive seat belt pretensioner deployment events have not occurred. |
| • | One frontal air bag deployment has not occurred. |
The DTC becomes a latched code after 3 consecutive pretensioner deployments or 1 frontal air bag deployment. You cannot clear a latched code.
Diagnostic Aids
Important: The seat belt pretensioners may deploy for impacts that are not severe enough to warrant frontal air bag deployment. The SDM is capable of sustaining 3 pretensioner deployment events, or one frontal deployment event. After the maximum number of deployments has occurred, DTC B0052 sets and becomes a latched code, which cannot be cleared.
When DTC B0053 is accompanied by additional DTCs, other than B0052, repair the malfunction causing the other DTCs before replacing the SDM.
Reference Information
Schematic Reference
Connector End View Reference
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Important:
• The seat belt pretensioners may deploy for impacts that are not severe enough to warrant frontal or side air bag deployment. The SDM is capable of sustaining 3 pretensioner deployment events, or one frontal or side deployment event. After the maximum
number of deployments has occurred, DTC B0052 sets and becomes a latched code, which cannot be cleared. • When DTC B0053 is accompanied by additional DTCs, other than B0052, repair the malfunction causing the other DTCs before replacing the SDM.
- Ignition OFF, verify no signs of inflator module or pretensioner deployment exist.
- Verify DTC B0053 is not set.
- Verify DTC B0052 is not set.
| ⇒ | If any signs of deployment exist, refer to Repairs and Inspections Required After a Collision. |
| ⇒ | If DTC B0053 is set along with additional DTCs, other than B0052, repair the malfunction causing the DTCs before replacing the SDM. |
| ⇒ | If the DTC resets, replace the SDM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for SDM replacement, setup, and programming.
