- Inspect the input speed sensor (ISS) assembly (250)
for the following conditions:
• | Cracked or damaged housing |
• | Worn or missing harness brackets |
• | Damaged or worn wining or electrical connector |
• | Loose, missing or damaged mounting bolt insert |
- Remove the input speed sensor (ISS) O-ring (249)
and discard.
- Lubricate NEW O-ring (249) with transmission fluid and position
in the ISS O-ring groove.
- Insert the ISS (250) into oil pump ISS bore and fully seat.
- Align ISS bolt insert with oil pump mounting bolt hole.
Notice: Refer to Fastener Notice in the Preface section.
- Install retaining bolt (247).
Tighten
Tighten the retaining bolt to 9-11 N·m
(6.6-8.1 lb ft).
- Route the ISS assembly (250) wire harness as
shown. Install harness bracket #1 and #2 in the locations shown. Ensure the
wire harness lays flat against the pump housing.