Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement. Holden VE Ute 2009

For 1990-2009 cars only

Makes 🢒 Holden 🢒 2009 🢒 VE Ute 🢒 Transmission 🢒 Automatic Transmission - 6L50/6L80/6L90 🢒 Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement

Callout

Component Name

Notice: Refer to General Repair Instructions in the Preface section.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Place a suitable drain pan under the transmission.

Transmission Fluid Pan Bolt (Qty: 18)

Tip
Tighten the bolts in the sequence shown.

Tighten
9 N·m (80 lb. in)

Transmission Fluid Pan Assembly

•	Check the condition of the draining fluid. Refer to Transmission Fluid Check .

•	Fill the transmission with the proper fluid. Refer to Transmission General Specifications .

•	Fill the transmission with the proper amount of transmission fluid. Refer to Fluid Capacity Specifications and Transmission Fluid Check .

Transmission Fluid Pan Gasket

Tip
The fluid pan gasket is reusable. Inspect the gasket to determine if it may be reused.

NEW Fluid Filter Assembly

Tip
Pull the fluid filter assembly straight out. Do not bend or twist the filter neck.

NEW Fluid Filter Seal Assembly

Notice: Refer to Fastener Notice in the Preface section.

Notice: Refer to General Repair Instructions in the Preface section.

•	Use a screwdriver or snap ring pliers to remove the filter seal.

•	Use the DT 47848 and the J 42183 to install the filter seal.

•	Lubricate the filter seal with transmission fluid before installing the filter.

•	DT 47848 .

•

J 42183 .