Important: If the vehicle has been in a collision, refer to Repairs and Inspections Required After a Collision in Seat Belts. For additional information.

Perform the following inspection of the driver and passenger seat:

1. Ignition ON. Verify proper operation of the seat belt reminder lamp with the belt buckled and with the belt unbuckled. Refer to Seat Belt System Description and Operation in Seat Belts.
2. Inspect the shoulder belt guide in order to make sure that the following conditions are met:

•	The seat belt webbing is seated flat in the guide slot.

•	The seat belt webbing does not bind.

3. Verify that the seat belt buckle faces inboard and is accessible.
4. Verify that the seat belt retractor units are securely attached.
5. Verify that the seat belt anchor bolts are secure.
6. Fully extend the seat belt webbing. Verify that the seat belt webbing does not have any twists or tears.
7. Allow the seat belt webbing to retract. Verify that the seat belt webbing returns freely and completely back into the retractor.
8. Snap the seat belt latch plate into the buckle.
9. Sharply tug on the seat belt latch plate and the buckle. Verify that the seat belt latch plate and the buckle remain locked when tugged.
10. Push the button on the buckle.

•	Verify that the seat belt latch plate releases easily from the buckle.

•	Verify that the button returns to its original position.

1. Fasten the seat belts, an assistant is needed when the retractor under test is not part of the driver seat belt.
2. Accelerate the vehicle slowly to 16 km/h and apply the brakes firmly.
3. Verify that the seat belt locks when braking firmly.
4. If the belt does not lock, proceed with the following steps.

Important: When performing this check , note the position the retractor is mounted.





4.1.	Remove the seat belt retractor assembly.

4.2.	Tilt the seat belt retractor slowly.

4.3.	Make sure that the seat belt webbing can be pulled from the retractor at an inclination from the vehicle position of 15 degrees or less and cannot be pulled from the retractor at an inclination of 30 degrees or more.

4.4.	If the seat belt retractor does not operate as described, replace the retractor assembly. Refer to Front Seat Belt Replacement .