GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution in the Preface section.

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1670493  Size: SH
  1. Disconnect the negative battery cable.
  2. Remove the trim from the center pillar.
  3. Remove the side impact sensor mounting bolts.
  4. Remove the side impact sensor.

Installation Procedure


    Object Number: 1670493  Size: SH
  1. Install the side impact sensor.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the side impact sensor mounting bolts.
  4. Tighten
    Tighten the side impact sensor mounting bolts to 8 N·m (71 lb in).

  5. Install the trim to the center pillar.
  6. Connect the negative battery cable.