GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2008 🢒 Viva 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Accelerator Pedal Position Sensor Replacement

Removal Procedure

    Object Number: 1962902 Size: SH
  1. Turn the ignition switch to the off position.
  2. Disconnect the electronic throttle control (ETC) connector from the accelerator pedal.
  3. Remove the 3 accelerator pedal retaining nuts.
  4. Remove the accelerator pedal.

Installation Procedure

    Object Number: 1962902 Size: SH
  1. Position the accelerator pedal.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the 3 accelerator pedal retaining nuts.

    3. Tighten
    Tighten the lower accelerator pedal retaining nuts to 22 N·m (16 lb ft).

  3. Connect the ETC connector to the accelerator pedal.