1. Connect a scan tool.
2. Check for engine control diagnostic trouble codes (DTCs).

Is the vehicle speed sensor DTC set?

--

Go to Diagnostic System Check - Vehicle

Go to Step 2

1. Turn the ignition OFF.
2. Disconnect engine control module (ECM) connector.
3. Remove the instrument cluster.
4. Measure continuity between ECM terminal K30 (MR-140), terminal B31 (HV-240), terminal 40 (SIRUS D4) in Gasoline and terminal K89 in Diesel and the instrument cluster terminal B3, terminal A21 in Diesel.

Does the ohmmeter indicate the specified value?

0 ohms

Go to Step 4

Go to Step 3

Repair the open circuit between the instrument cluster connector terminal B3, terminal A21 in Diesel and the ECM terminal K30 (MR-140), terminal B31 (HV-240), terminal 40 (SIRUS D4) in Gasoline and terminal K89 in Diesel.

Is the repair complete?

--

System OK

--

Replace the fuel gage.

Is the repair complete?

--

System OK

--