Special Tools
CH-47717
Fuel Lock Ring Remover Tool
Removal Procedure
Warning: Gasoline or gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or diesel fuel in an open container, due to the possibility
of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.
Warning: Provide proper ventilation when working with fuel in enclosed areas where fuel vapors can collect. The lack of adequate ventilation may result in personal injury.
Warning: Always wear safety goggles when working with fuel in order to protect the eyes from fuel splash.
Warning: Remove the rear compartment floor trim to provide technician contact with the vehicle's metal surfaces. Failure to remove the rear compartment floor trim may cause a static electricity discharge
to ignite any fuel vapor resulting in personal injury and vehicle damage.
Warning: Fuel Vapors can collect while servicing fuel system parts in enclosed areas such as a trunk. To reduce the risk of fire and increased exposure to vapors:
• | Use forced air ventilation such as a fan set outside of the trunk. |
• | Plug or cap any fuel system openings in order to reduce fuel vapor formation. |
• | Clean up any spilled fuel immediately. |
• | Avoid sparks and any source of ignition. |
• | Use signs to alert others in the work area that fuel system work is in process. |
Caution: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes and passages.
Caution: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
• | The fuel pipe connections |
• | The areas surrounding the connections |
Note:
• | Always replace the fuel sender assembly O-rings when reinstalling the fuel sender assembly. |
• | Always maintain cleanliness when servicing fuel system components. |
• | Do not bend the arm of the fuel gage float while removing the fuel sender assembly. |
- Remove the fuel pump. Refer to
Fuel Pump Replacement.
- Disconnect the fuel sender insulator connector.
- To disconnect the fuel pump terminal, push the terminal wedge (1) in the insulator.
- Push the wedge (1) outside, then pull the wires to disconnect from the connector.
- Remove the fuel level sensor (1) from the sender housing, then remove the sender housing (2).
- Remove the fuel sender assembly (1).
Installation Procedure
Caution: Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware.
Do not repair sections of fuel pipes.
- Wind the wires (1) around the sender assembly (2).
Note: Failure to install the fuel sender assembly correctly will result in fuel gauge inaccurate reading.
- Install the sender assembly onto the fuel pump assembly (1).
Note: Failure to install the fuel level sensor correctly will result in fuel level warning lamp inaccurate reading.
- Install the fuel level sensor onto the fuel sender housing.
- Connect the wires into the insulator as follows:
- Connect the fuel sender insulator connector.
- Install the fuel pump. Refer to
Fuel Pump Replacement.