GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 Viva 🢒 Brakes 🢒 Disc Brakes 🢒 Front Brake Caliper Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Mark the position of the front wheels relative to the wheel hubs and remove the wheels. Refer to Tire and Wheel Removal and Installation.

    3. Warning: Refer to Brake Dust Warning in the Preface section.


    Object Number: 1289963 Size: SH
  3. Remove the fitting and the washers that attach the brake hose to the caliper.

    4. Warning: Refer to Brake Fluid Irritant Warning in the Preface section.

    Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution in the Preface section.

  4. Disconnect the brake hose. Plug the openings in the caliper and the brake hose in order to prevent fluid loss and contamination.
  5. Remove the caliper mounting bolts from the steering knuckle.
  6. Remove the caliper assembly.

Installation Procedure
  1. Ensure the slide pins are lubricated with Silicone Brake Lubricant, GM P/N 89021536, ACDelco P/N 89021537 (Canadian P/N 89021538), or equivalent. If necessary, refer to Front Brake Caliper Overhaul.

    2. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1289964 Size: SH
  2. Install the caliper assembly with the mounting bolts and tighten to 95 N·m (70 lb ft).
  3. Install the brake hose to the caliper with the washers and the brake hose inlet fitting and tighten to 40 N·m (30 lb ft).
  4. Install the front wheels. Refer to Tire and Wheel Removal and Installation.
  5. Lower the vehicle.

    6. Warning: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in personal injury.

  6. With the engine OFF, gradually apply and release the brake pedal several times in order to position the caliper piston and the pads.
  7. Bleed the brake system. Refer to Hydraulic Brake System Bleeding.