GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 Viva 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Brake Pressure Modulator Valve Assembly Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    Object Number: 1290102 Size: SH
  1. Disconnect the negative battery cable.
  2. Disconnect the 31-pin antilock brake system (ABS) wiring harness connector from its socket on the electronic brake control module (EBCM).
  3. Cover the connector and the socket with shop cloths to protect the components from brake fluid.

    4. Object Number: 1290103 Size: SH
  4. Remove the brake pipes from the brake pressure modulator valve. You may have to loosen the brake pipe nuts on the master cylinder to allow for moving those pipes out of the way.
  5. Loosen the mounting nuts on the brake pressure modulator valve.
  6. Move the brake pipes aside far enough to allow for lifting the ABS unit out of the mounting bracket.
  7. Tighten the brake pipe nuts on the master cylinder to avoid leaking brake fluid.
  8. Cap the brake pipes.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1290105 Size: SH
  1. Insert the ABS brake pressure modulator valve into the mounting bracket and install the nuts and tighten to 15 N·m (11 lb ft).
  2. Remove the screw plugs and install all of the hydraulic brake pipes and tighten to 22 N·m (16 lb ft).
  3. Connect the 31-pin wiring harness connector J1.
  4. Connect the negative battery cable.
  5. Bleed the hydraulic system. Refer to Hydraulic Brake System Bleeding.
  6. Refer to Control Module References for programming and setup information.