Removal Procedure
- Remove the cross car brace, if fitted. Refer to Front End Panel Module Carrier Assembly Replacement .
- Detach the engine covers (1) from the outer retaining clips (2).
- Detach the engine covers (1) from the ball studs (2).
- Remove the engine covers (1).
Important: The right hand engine cover has only one outer retaining clip (2) at the front. The left hand engine cover has one front and one rear outer retaining clip.
Important: Grasp and pry the engine covers (1) upwards to detach the engine covers (1) from the outer retaining clips (2).
Important: Disengage the engine covers (1) from the ball studs (2) by pulling up firmly on the rear and front of the engine covers (1).
Installation Procedure
- Position the engine covers (1) over the intake manifold so the grommets are aligned with the ball studs (2).
- Attach the engine covers (1) to the ball studs (2).
- Attach the engine covers (1) to the outer retaining clips (2).
- Install the cross car brace, if fitted. Refer to Front End Panel Module Carrier Assembly Replacement
Important: Press the engine covers (1) down firmly near the ball studs to attach the engine covers (1) to the ball studs (2).
Important: The right hand engine cover has only one outer retaining clip (2) at the front. The left hand engine cover has one front and one rear outer retaining clip.
Important: Press the engine covers (1) down firmly near the outer retaining clips to attach the engine covers (1) to the outer retaining clips (2).
