Diagnostic Instructions
DTC Descriptor
DTC B0055 00: Side Airbag Deployment Commanded
Circuit/System Description
The inflatable restraint sensing and diagnostic module (SDM) contains a sensing device that converts vehicle velocity changes into an electrical signal. The SDM compares this electrical signal to a value stored in memory. When the generated signal exceeds
the stored value, the SDM performs additional signal processing and compares the generated signals to values stored in memory. When 2 of the generated signals exceed the stored values, the SDM will cause current to flow through the inflator modules, deploying
the side air bags and causing DTC B0055 to set.
This DTC is set when the SDM has commanded an air bag deployment with no faults present.
Conditions for Running the DTC
Ignition voltage is between 9-16 volts.
Conditions for Setting the DTC
| • | The SDM detects a frontal impact of sufficient force to warrant deployment of the frontal inflator modules. |
| • | The SDM detects a side impact of sufficient force to warrant deployment of a side inflator module and/or roof rail module. |
Action Taken When the DTC Sets
| • | The SDM requests the instrument panel cluster (IPC) to illuminate the AIR BAG indicator. |
| • | The SDM records crash data. |
Conditions for Clearing the DTC
DTC B0055 is a latched code and cannot be cleared.
Reference Information
Schematic Reference
SIR Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Ignition OFF, Verify that the vehicle does not show any signs of side impact or frontal inflator module deployment.
- Verify DTC B0055 is not set.
| ⇒ | If DTC B0055 is set, replace the SDM. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for SDM replacement, setup, and programming
