GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2008 🢒 WM Sedan 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Inside Air Temperature Sensor Replacement

Removal procedure
  1. Remove the driver side instrument panel lower trim. Refer to Instrument Panel Insulator Panel Replacement - Right Side.

    2. Object Number: 1958746 Size: SH
  2. Remove the aspirator tube (2) from the rear of the inside air temperature sensor (1).
  3. Disconnect the inside air temperature sensor electrical connector (3).

    4. Object Number: 1958693 Size: SH

    Important: From the front of the inside air temperature sensor (3) use a suitable tool to push down on the four inside air temperature sensor to instrument panel carrier retaining clips (1). Withdraw the inside air temperature sensor (1) rearwards towards the bulkhead from the instrument panel carrier (3) .

  4. Remove the inside air temperature sensor (3) from the instrument panel carrier (2).

Installation Procedure

    Object Number: 1958693 Size: SH

    Important: Make sure the inside air temperature sensor to instrument panel carrier retaining clips (1) are correctly engaged to avoid an induced rattle condition.

  1. Install the inside air temperature sensor (3) to the instrument panel carrier (2).

    2. Object Number: 1958746 Size: SH
  2. Connect the inside air temperature sensor electrical connector (3).
  3. Install the aspirator tube (2) to the rear of the inside air temperature sensor (1).
  4. Install the driver side instrument panel lower trim cover. Refer to Instrument Panel Insulator Panel Replacement - Right Side.