Park/Neutral Position Switch Replacement LHD
Removal Procedure
Caution: Refer to Safety Glasses Caution in the Preface section.
Caution: Refer to Vehicle Lifting Caution in the Preface section.
- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- While holding the transmission selector lever (1),
remove the lever retaining nut (2).
- Position the lever and shift linkage out of the way.
- Remove the wiring harness connector (CPA) securing pin (3).
- Pull the connector release clip downward and remove the park neutral position
(PNP) switch electrical connector (5).
- Remove the PNP switch bolts (6).
- Remove the PNP switch from the transmission.
Installation Procedure
- install the PNP switch on the transmission.
- Install the PNP switch retaining bolts (6) finger tight only at
this time.
Notice: Refer to Fastener Notice in the Preface section.
- Install the selector lever and nut on the manual selector shaft.
Tighten
Tighten the retaining nut to 25 N·m
(18 lb ft).
- Slightly rotate the PNP switch back and forth until a central position
is obtained; then lightly tighten the front screw.
- Connect the PNP switch electrical connector (2).
- Install the PNP wiring harness electrical connector, do not install the
securing pin at this time.
- Ensure that the engine can only be started in the Park and Neutral positions.
Adjust the switch as necessary.
- Tighten the retaining bolts.
Tighten
Tighten the retaining bolts to 25 N·m
(18 lb ft).
- Compress the electrical connector release clip, then install the securing
pin.
- Lower the vehicle.
- Ensure that the engine can only be started in the Park and Neutral positions.
- Check the reverse lamps for proper operation.