GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 WM Sedan 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust

Removal Procedure

    Important: Do not disconnect the power steering fluid lines/hoses from the reservoir.

  1. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Power Steering Fluid Reservoir Replacement .

    2. Object Number: 1949771 Size: SH
  2. Remove the camshaft position (CMP) sensor electrical connector (1) from the CMP sensor (2).

    3. Object Number: 1949774 Size: SH
  3. Remove the CMP sensor to engine front cover retaining bolt (1).
  4. Remove the CMP sensor (2) from the engine front cover.

Installation Procedure

    Object Number: 1949774 Size: SH
  1. Install the CMP sensor to the engine front cover.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the CMP sensor to engine front cover retaining bolt (1).

    3. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1949771 Size: SH
  3. Install the CMP sensor electrical connector (1) to the CMP sensor (2).
  4. Install the power steering fluid reservoir. Refer to Power Steering Fluid Reservoir Replacement .