GM Service Manual Online
For 1990-2009 cars only

Adjustment Procedure

  1. Cycle the sunroof window from the full open to the full closed position.
  2. Important: Correct adjustment cannot be achieved if the sunroof window is closed from the vent position.


    Object Number: 1938691  Size: SH
  3. Remove the top side of the sunroof panel side opening closeout panel covers (1) from the 3 clips located on the inner edge of the sunroof window (2) in order to access the window adjustment screws.
  4. Cycle the sunroof to the closed position.

  5. Object Number: 1939015  Size: SH
  6. Loosen the adjusting screws (1) on each side of the sunroof window.
  7. Centre the window front to rear in the opening.
  8. Important: Do not fully tighten the sunroof retaining screws at this stage.

  9. Adjust the front of the sunroof window (2) from flush to 1 mm (0.04 in) (1) below the top surface of the roof panel (3).
  10. Do not fully tighten at this stage.

    Important: Do not fully tighten the sunroof retaining screws at this stage.

  11. Adjust the rear of the sunroof window (2) from flush to 1 mm (0.04 in) above the top surface of the roof panel (1).
  12. Do not fully tighten at this stage.

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1939015  Size: SH
  13. Tighten the sunroof glass to the sunroof frame retaining screws (1).
  14. Tighten
    Tighten the screws to 3 N·m (27 lb in).


    Object Number: 1938691  Size: SH
  15. Install the sunroof panel side opening closeout covers (2).
  16. Cycle the sunroof window through all of the positions.
  17. Verify the sunroof window fore/aft adjustment.
  18. Verify the front and rear height adjustment.
  19. Readjust the sunroof window, if necessary.