GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2003 🢒 Ascender - 2WD 🢒 Body and Accessories 🢒 Roof 🢒 Sunroof Module Assembly Replacement

Removal Procedure

    Important: Do not remove the headliner.

  1. Lower the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.

    2. Object Number: 749612 Size: SH
  2. Disconnect the sunroof harness electrical connector.

    3. Important: Do not remove the drain hoses.

  3. Disconnect the drain hoses from the sunroof assembly. Refer to the following procedures:
    4. •  Sunroof Housing Front Drain Hose Replacement
    •  Sunroof Housing Rear Drain Hose Replacement

    Object Number: 749611 Size: SH
  4. Support the sunroof with an assistant.
  5. Remove the bolts that retain the sunroof module assembly to the roof panel
  6. Remove the sunroof module assembly from the vehicle and place on a clean, prepared surface with an assistant.
  7. Remove the sunroof motor/actuator from the sunroof module assembly. Refer to Sunroof Motor/Actuator Replacement .
  8. Remove the sunroof control module from the sunroof module assembly. Refer to Sunroof Control Module Replacement .
  9. Remove the sunroof window from the sunroof module assembly. Refer to Sunroof Window Replacement .
  10. Remove the sunroof sunshade panel from the sunroof module assembly. Refer to Sunroof Sunshade Replacement .

Installation Procedure
  1. Install the sunroof sunshade panel to the sunroof module assembly. Refer to Sunroof Sunshade Replacement .
  2. Install the sunroof window to the sunroof module assembly. Refer to Sunroof Window Replacement .
  3. Install the sunroof control module to the sunroof module assembly. Refer to Sunroof Control Module Replacement .
  4. Install the sunroof motor/actuator to the sunroof module assembly. Refer to Sunroof Motor/Actuator Replacement .

    5. Object Number: 749611 Size: SH
  5. Position the sunroof module assembly to the vehicle with an assistant.

    6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Install the bolts that retain the sunroof module assembly to the roof panel.

    7. Tighten
    Tighten the bolts to 10 N·m (7 lb ft).

  7. Connect the drain hoses to the sunroof module assembly. Refer to the following procedures:
    8. •  Sunroof Housing Front Drain Hose Replacement
    •  Sunroof Housing Rear Drain Hose Replacement

    Object Number: 749612 Size: SH
  8. Connect the sunroof harness electrical connector.
  9. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.