Tools Required

1. Adjust the backlash. Refer to Backlash Inspection and Adjustment .
2. Inspect the alignment mark between the differential bearing adjuster and the differential carrier assembly case. If the line between the differential bearing adjuster and the differential carrier assembly case is not aligned, re-align the 2 components as necessary.



3. Install the left side inner shaft seal using the J 45225  (2) and the J 8092  (1).



4. Install the right side inner shaft seal using the J 45225  (2) and the J 8092  (1).

Notice: Refer to Component Fastener Tightening Notice in the Preface section.

5. Install the drain plug.

Tighten
Tighten the drain plug to 32 N·m (24 lb ft).

6. Install the fill plug.

Tighten
Tighten the fill plug to 32 N·m (24 lb ft).