GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2004 🢒 Ascender - 2WD 🢒 General Information 🢒 General Information 🢒 Front Bumper Fascia Replacement

Removal Procedure
  1. Remove the grille. Refer to Grille Replacement in Exterior Trim.

    2. Object Number: 740665 Size: SH
  2. Remove the 2 bolts that retains the top of the fascia to the headlamp panel assembly.
  3. Remove the push-pin that retains the top of the fascia to the headlamp panel assembly.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    5. Object Number: 740663 Size: SH
  5. Remove the push-pins (3) that retain the fascia to the fascia support rods (2).
  6. Remove the fog lamps from the fascia. Refer to Front Fog Lamp Replacement in Lighting Systems.
  7. Remove the air deflector. Refer to Front Bumper Fascia Air Deflector Replacement .

    8. Object Number: 740665 Size: SH
  8. Remove the 4 push-pins that retain the bottom of the fascia to the headlamp panel assembly.
  9. Release the body side attachment tabs and pull the fascia straight forward from the wheelhouse opening in order to remove the fascia from the vehicle.

Installation Procedure

    Object Number: 740665 Size: SH
  1. Position the fascia to the vehicle, ensuring that the body side attachment tabs are fully seated.
  2. Install the 4 push-pins that retain the bottom of the fascia to the headlamp panel assembly.

    3. Object Number: 740663 Size: SH
  3. Install the push-pins (3) that retain the fascia to the fascia support rods (2).
  4. Install the air defector. Refer to Front Bumper Fascia Air Deflector Replacement .
  5. Install the fog lamps. Refer to Front Fog Lamp Replacement in Lighting Systems.
  6. Lower the vehicle.

    7. Object Number: 740665 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the 2 bolts that retain the top of the fascia to the headlamp panel assembly.

    8. Tighten
    Tighten the bolts to 10 N·m (89 lb in).

  8. Install the push-pin that retains the center of the top of the fascia to the headlamp panel assembly.