GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2006 🢒 Ascender - 2WD 🢒 Suspension 🢒 Suspension General Diagnosis 🢒 Stabilizer Shaft Link Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

    2. Object Number: 744889 Size: SH
  2. Remove the stabilizer shaft link retaining nuts.

    3. Notice: Do not pry on the stabilizer shaft link. Use care when removing or installing the stabilizer shaft link in order to avoid tearing or puncturing the stabilizer shaft link boot. Damage to the stabilizer shaft link boot will lead to damage to the stabilizer shaft link.

  3. Disconnect the stabilizer shaft link from the frame.
  4. Disconnect the stabilizer shaft link from the stabilizer shaft and remove the stabilizer shaft link.

Installation Procedure

    Object Number: 744889 Size: SH
  1. Connect the stabilizer shaft link to the stabilizer shaft and to the frame.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the stabilizer shaft link retaining nuts.

    3. Tighten
    Tighten the stabilizer shaft nuts to 90 N·m (66 lb ft).

  3. Lower the vehicle.