GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2006 🢒 Ascender - 2WD 🢒 Body 🢒 Interior Trim 🢒 Center Pillar Garnish Molding Replacement

Removal Procedure

    Object Number: 740434 Size: SH
  1. Remove the front and rear door sill plates. Refer to Front Side Door Sill Plate Replacement and Rear Side Door Sill Plate Replacement .
  2. Move the seat to a forward position.
  3. Partially remove the door opening weatherstrip from the door opening where it interferes with molding removal.
  4. Release the 4 retaining clips that attach the garnish molding to the center pillar.
  5. Disconnect the electrical connector from the temperature sensor, if equipped.
  6. Remove the garnish molding from the vehicle.

Installation Procedure

    Object Number: 740434 Size: SH
  1. Position the garnish molding to the center pillar.
  2. Connect the electrical connector to the temperature sensor, if equipped.
  3. Index the positioning tabs on the garnish molding to the corresponding holes in the center pillar.
  4. Seat the 4 garnish molding retaining tabs to the center pillar.
  5. Fully install the door opening weatherstrip.
  6. Return the seat to neutral position.
  7. Install the front and rear door sill plates. Refer to Front Side Door Sill Plate Replacement and Rear Side Door Sill Plate Replacement .