GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2006 🢒 Ascender - 2WD 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 4L60-E/4L65-E/4L70-E 🢒 Range Selector Lever Cable Replacement

Removal Procedure

    Object Number: 744174 Size: SH
  1. Ensure that the vehicle is in the park position.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the end of the range selector cable from the transmission range selector lever ball stud (6).
  4. Remove the retainer (5) from the range selector cable.
  5. Remove the range selector cable (4) from the bracket (1).
  6. Remove the cable from the retainer (3) on the floor panel. If the vehicle is equipped with 4WD, remove the cable from the retainers located on the transfer case.

    7. Object Number: 744168 Size: SH
  7. Push the cable grommet (2) up through the floor panel.
  8. Lower the vehicle.

    9. Object Number: 1234306 Size: SH
  9. Remove the console. Refer to Console Replacement in Instrument Panel, Gauges, and Console.
  10. Remove the drivers side front mat and carpet. Refer to Front Floor Panel Carpet Replacement in Interior Trim.

    11. Object Number: 744173 Size: SH
  11. Remove the end of the range selector cable (1) from the floor control ball stud.
  12. Remove the range selector cable (2) from the floor shift control assembly.
  13. Remove the tape and grommet on the shift cable from the floor panel.
  14. Remove the range selector cable (3) from the vehicle.

Installation Procedure

    Object Number: 744168 Size: SH
  1. Push the cable down through the floor panel and install the grommet (2).

    2. Object Number: 744173 Size: SH
  2. Install the range selector cable (2) to the floor shift control assembly.
  3. Install the end of the range selector cable (1) to floor control ball stud.
  4. Install the drivers side front mat and carpet. Refer to Front Floor Panel Carpet Replacement in Interior Trim.

    5. Object Number: 1234306 Size: SH
  5. Install the console. Refer to Console Replacement in Instrument Panel, Gauges, and Console.
  6. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    7. Object Number: 744174 Size: SH
  7. Install the cable to the retainer (3) on the floor panel. If the vehicle is equipped with 4WD, install the cable to the retainers located on the transfer case.
  8. Install the range selector cable (4) to the bracket (1).
  9. Install the retainer (5) to the range selector cable.
  10. Install the end of the range selector cable to the transmission range selector lever ball stud (6).
  11. Adjust the range selector cable. Refer to Range Selector Lever Cable Adjustment .
  12. Lower the vehicle and check for proper operation.