Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Fog Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Data Communication Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Verify that the front fog lamps are always ON. Do the front fog lamps operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 | Remove the front fog lamp relay. Do the front fog lamps turn OFF? | Go to Step 4 | Go to Step 6 |
4 |
Was a ground signal found? | Go to Step 5 | Go to Step 8 |
5 | Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 9 | Go to Step 7 |
6 | Repair the short to voltage in the front fog lamp supply voltage circuit. Refer to Wiring Repairs . Did you complete the repair? | Go to Step 9 | -- |
7 | Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 9 | -- |
8 | Replace the front fog lamp relay. Refer to Relay Replacement . Did you complete the repair? | Go to Step 9 | -- |
9 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
