GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2007 🢒 Ascender - 2WD 🢒 Body Hardware and Trim 🢒 Exterior Trim 🢒 Rear License Plate Pocket Replacement

Removal Procedure

    Object Number: 1672805 Size: MH
  1. Open the liftgate.
  2. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  3. Remove the liftgate lock cylinder. Refer to Liftgate Lock Cylinder Replacement .
  4. Remove the license plate pocket wiring harness retainers from the liftgate.
  5. Disconnect the main license plate pocket electrical connector.
  6. Remove the nuts retaining the license plate pocket to the liftgate.
  7. Remove the license plate pocket from the liftgate.

Installation Procedure

    Object Number: 1672805 Size: MH
  1. Install the license plate pocket to the liftgate.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the nuts retaining the license plate pocket to the liftgate.

    3. Tighten
    Tighten the license plate pocket nuts to 10 N·m (89 lb in).

  3. Connect the main license plate pocket electrical connector.
  4. Install the license plate pocket wiring harness retainers to the liftgate.
  5. Install the lock cylinder. Refer to Liftgate Lock Cylinder Replacement .
  6. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .