GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2007 🢒 Ascender - 2WD 🢒 Body Hardware and Trim 🢒 Interior Trim and Paneling 🢒 Rear Quarter Trim Panel Replacement - Right Side

Removal Procedure

    Object Number: 740429 Size: SH
  1. Remove the cargo shade/cover.
  2. Remove the inflator access panel.
  3. Remove the right rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement .
  4. Remove the lift gate sill plate. Refer to Liftgate Door Sill Plate Replacement .
  5. Remove the right rear door sill panel. Refer to Rear Side Door Sill Plate Replacement .
  6. Remove the lower seat belt anchor bolt.
  7. Release the retaining clips that retain the trim panel to the body.

    8. Object Number: 740427 Size: SH
  8. Partially remove the trim panel in order to remove the inflator switch from the inflator bezel.
  9. Remove the auxiliary air outlet washer and retaining nut.
  10. Feed the auxiliary air outlet through the inflator bezel.
  11. Remove the inflator bezel from the trim panel.
  12. Disconnect the 12-volt power supply electrical connector.
  13. Remove the trim panel from the vehicle.

Installation Procedure

    Object Number: 740427 Size: SH
  1. Position the trim panel to the vehicle.
  2. Connect the 12-volt power supply electrical connector.
  3. Install the inflator bezel to the trim panel.
  4. Feed the auxiliary air outlet through the hole in the inflator bezel.

    5. Notice: Refer to Fastener Notice in the Preface section.

  5. Install the auxiliary air outlet washer and retaining nut.

    6. Tighten
    Tighten the nut to 2 N·m (18 lb in).

  6. Install the inflator switch to the inflator bezel.

    7. Object Number: 740429 Size: SH
  7. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
  8. Align the locating tabs on the trim panel to the holes in the body.
  9. Seat the clips that retain the trim panel to the body.
  10. Install the seat belt lower anchor.

    11. Tighten
    Tighten the anchor bolt to 70 N·m (52 lb ft).

  11. Install the right rear door sill panel. Refer to Rear Side Door Sill Plate Replacement .
  12. Install the lift gate sill plate. Refer to Liftgate Door Sill Plate Replacement .
  13. Install the trim panel-rear quarter upper. Refer to Quarter Upper Trim Panel Replacement .