GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2007 🢒 Ascender - 2WD 🢒 Body Hardware and Trim 🢒 Interior Trim and Paneling 🢒 Rear Floor Front Trim Plate Replacement

Removal Procedure
  1. Lower the midgate to the cargo position.
  2. Raise the hinged filler panel on the back of the midgate.

    3. Object Number: 1236706 Size: SH
  3. Remove the pushpins securing the rear floor front trim panel end covers by unscrewing the retainer pin.
  4. Remove the rear floor front trim panel end covers.
  5. Remove 2 push pin fasteners by lifting up on each end of the rear floor front trim panel.

    6. Object Number: 1236713 Size: SH
  6. Grasp the front edge of the rear floor front trim panel and pull straight up to release the retaining clips along the front edge.
  7. Remove the rear floor front trim panel by pulling straight up to release the retaining clips along the rear edge.
  8. Remove the rear floor front trim panel from the vehicle

Installation Procedure

    Object Number: 1236713 Size: SH
  1. Ensure that the retaining clips are securely installed on the back side of the rear floor front trim panel.
  2. Lift up on the front edge of the cargo mat and slide the rear floor trim panel into position.
  3. Position the rear floor front trim panel so that the fasteners align with their respective holes.
  4. Install the rear floor front trim panel by pressing the retaining clips and fasteners into the sheet metal openings.

    5. Object Number: 1236706 Size: SH
  5. Install the rear floor front trim panel end covers by pressing them in place.
  6. Install the pushpin in each rear floor front trim panel end cover by pushing the pin into the hole and screwing in the retainer pin.