GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2007 🢒 Ascender - 2WD 🢒 Body Repair 🢒 Bolted Exterior Body Panels and Closures 🢒 Weatherstrip Side Retainer Replacement

Removal Procedure

    Object Number: 588275 Size: SH
  1. Open the front door.
  2. Remove the push-pin retainers (2) from the front door sealing auxiliary weatherstrip located at the base of the pillar.

    3. Object Number: 441415 Size: SH
  3. Pull back the front door sealing weatherstrip (1) in order to expose the windshield side reveal molding screws (2).

    4. Object Number: 301107 Size: SH
  4. Remove the screws from the windshield side reveal molding.
  5. Remove the reveal molding from the windshield pillar.

Installation Procedure

    Object Number: 441415 Size: SH
  1. Install the side reveal molding (2) to the windshield pillar. Ensure the bottom edge is tucked under the outer edge of the air inlet panel grille.

    2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 301107 Size: SH
  2. Install the screws to the side reveal molding.

    3. Tighten
    Tighten the screws to 2 N·m (18 lb in).


    Object Number: 588275 Size: SH
  3. Install the push-pin retainers (2) to the front door sealing auxiliary weatherstrip located at the base of the pillar.
  4. Close the door.