GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2007 🢒 Ascender - 2WD 🢒 Seats 🢒 Seat Hardware, Trim, and Upholstery 🢒 Driver or Passenger Seat Adjuster Switch Bezel Replacement

Removal Procedure

    Object Number: 752955 Size: SH
  1. Remove the 3 screws that retain the switch bezel to the seat.

    2. Object Number: 752953 Size: SH
  2. Partially remove the switch bezel from the seat.
  3. Remove the seat switches from the switch bezel by releasing the retaining tabs Refer to Power Seat Switch Replacement .
  4. Remove the lumbar switch from the switch bezel by releasing the retaining tabs. Refer to Front Seat Lumbar Control Switch Replacement.
  5. Remove the switch bezel from the seat .

Installation Procedure

    Object Number: 752953 Size: SH
  1. Install the lumbar switch to the switch bezel, verifying that the retaining tabs are fully seated. Refer to Front Seat Lumbar Control Switch Replacement.
  2. Install the seat switches to the switch bezel, verifying that the retaining tabs are fully seated. Refer to Power Seat Switch Replacement.

    3. Object Number: 752955 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the switch bezel to the seat with the 3 screws.

    4. Tighten
    Tighten the front seat switch bezel screws to 3 N·m (26 lb in).