• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
Battery Positive Voltage (+) | -- | 1 | -- | -- |
Left Audio Signal (+) | 2, 3 | 2 | 2, 3 | -- |
Right Audio Signal (+) | 4, 5 | 4 | 4, 5 | -- |
Audio Common Signal (-) | 6, 7 | 6 | 6, 7 | -- |
Ground | -- | 1 | -- | -- |
1. DVD Player Inoperative -- headphones and remote control inoperative. 2. No or distorted left audio when listening to DVD. 3. No or distorted left audio when listening to XM radio. 4. No or distorted right audio when listening to DVD. 5. No or distorted right audio when listening to XM radio. 6. No or distorted audio on both channels when listening to DVD. 7. No or distorted audio on both channels when listening to XM radio. |
The infrared transmitter is located at the bottom of the moitor. When listening to the headphones, the infrared transmitter sends an infrared signal to the headphones. The audio that is sent from the DVD player to the radio is a varying AC voltage. The audio from the radio when tuned to XM™ can be over the audio from the DVD or CD when using the wired headphones plugged into the rear seat audio (RSA). This is considered normal operation.
Radio/Navigation System Schematics
Control Module References for scan tool information
Note: Test or replace the remote batteries before performing the circuit/system verification.
⇒ | If the buttons on the DVD player do not function properly, replace the DVD player. |
⇒ | If the remote will not operate the DVD player, replace the remote. |
⇒ | If new remote will not operate the DVD Player, replace the DVD player. |
⇒ | If the remote will not operate the DVD player, replace the remote. |
⇒ | If new remote will not operate the DVD Player, replace the DVD player. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.