GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2009 🢒 Ascender - 2WD 🢒 Suspension 🢒 Front Suspension 🢒 Lower Control Arm Bracket Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation.
  3. Remove the stabilizer shaft link from the lower control arm. Refer to Stabilizer Shaft Link Replacement.

    4. Note: In the following step, it is NOT necessary to completely remove the lower control arm from the vehicle. Allow the lower control arm to remain attached to the knuckle assembly.

  4. Remove the lower control arm from the bracket. Refer to Lower Control Arm Replacement.

    5. Object Number: 1685591 Size: SH

    Note: Note the position of the spacer (1) on the front bushing.

  5. Remove the lower control arm bracket from the vehicle.

Installation Procedure

    Object Number: 1685591 Size: SH

    Note: Ensure the spacer (1) is in the proper position on the front bushing.

  1. Install the lower control arm bracket to the vehicle.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the lower control arm bracket mounting bolts to the frame.
    3. • Tighten the front lower control arm bracket mounting bolt to 260 N·m (192 lb ft).
    • Tighten the rear lower control arm bracket mounting bolts to 230 N·m (170 lb ft).
  3. Install the lower control arm to the lower control arm bracket. Refer to Lower Control Arm Replacement.
  4. Install the stabilizer shaft link to the lower control arm. Refer to Stabilizer Shaft Link Replacement.
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
  6. Lower the vehicle.
  7. Inspect the front wheel alignment. Refer to Wheel Alignment Specifications.