GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2009 🢒 Ascender - 2WD 🢒 Body Systems 🢒 Lighting 🢒 Tail Lamp Circuit Board Replacement

Removal Procedure
  1. Remove the tail lamp. Refer to Tail Lamp Replacement.

    2. Object Number: 732917 Size: SH
  2. Remove the 2 tail lamp circuit board retaining screws.
  3. Simultaneously release the bottom 4 locking tabs and partially remove the tail lamp circuit board.
  4. Release the top 2 locking tabs and remove the tail lamp circuit board from the tail lamp assembly.
  5. Remove the bulbs from the tail lamp circuit board.

Installation Procedure

    Object Number: 732917 Size: SH
  1. Install the bulbs to the tail lamp circuit board.
  2. Position the tail lamp circuit board to the tail lamp.
  3. Hold the top 2 locking tabs apart while pushing the tail lamp circuit board into place.
  4. Hold the bottom 4 locking tabs apart while pushing the tail lamp circuit board into place.
  5. Verify that the circuit board is fully seated with the locking tabs fully seated.

    6. Caution: Refer to Fastener Caution in the Preface section.

  6. Install the 2 tail lamp circuit board retaining screws.

    7. Tighten
    Tighten the screws to 1.9 N·m (17 lb in).

  7. Install the tail lamp. Refer to Tail Lamp Replacement.