GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2009 🢒 Ascender - 2WD 🢒 Brakes 🢒 Park Brake 🢒 Parking Brake Lever Replacement

Removal Procedure

    Object Number: 741613 Size: SH
  1. Remove the floor console. Refer to Console Replacement.
  2. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

    4. Object Number: 778146 Size: SH
  4. Disconnect the park brake cables from the equalizer.
  5. Lower the vehicle.
  6. Disconnect the electrical connector from the park brake warning indicator switch.

    7. Object Number: 748000 Size: SH
  7. Remove the remaining park brake lever nut.
  8. Remove the park brake lever assembly from the vehicle.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 748000 Size: SH
  1. Install the park brake lever assembly to the vehicle.
  2. Install the right front park brake lever nut.

    3. Tighten
    Tighten the nut to 25 N·m (18 lb ft).

  3. Connect the park brake warning indicator switch electrical connector.
  4. Raise the vehicle.

    5. Object Number: 778146 Size: SH
  5. Connect the park brake cables to the equalizer.
  6. Lower the vehicle.

    7. Object Number: 741613 Size: SH
  7. Install the floor console. Refer to Console Replacement.
  8. Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling.