GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2009 🢒 Ascender - 2WD 🢒 Transmission 🢒 Transfer Case - NVG 226-NP8 🢒 Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side

Removal Procedure
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.

    2. Object Number: 746671 Size: SH
  2. Disconnect the transfer case right rear speed sensor electrical connector.
  3. Remove the transfer case speed sensor.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 746671 Size: SH
  1. Install the transfer case right rear speed sensor.

    2. Tighten
    Tighten the speed sensor to 17 N·m (13 lb ft).

  2. Connect the transfer case right rear speed sensor electrical connector.
  3. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.