Removal Procedure
- Remove the center console. Refer to
Console Replacement
in Instrument Panel, Gages and Console.
- Remove the lower closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement
in Instrument Panel, Gages and Console.
- Remove the accessory trim plate. Refer to
Instrument Panel Accessory Trim Plate Replacement
in Instrument
Panel, Gages and Console.
- Remove
the 3 screws retaining the radio to the I/P.
- Partially remove the radio in order to disengage the rear alignment locator (1)
and to gain access to the electrical connectors.
- Disconnect the radio antenna cable.
- Disconnect the electrical connectors to the radio.
- Remove the radio from the I/P.
Installation Procedure
- Position
the radio to the I/P.
- Connect the electrical connectors to the radio.
- Connect the radio antenna cable to the radio.
- Position the radio rear alignment locator (1) into the I/P substrate.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the 3 screws retaining the radio to the I/P.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Install the accessory trim plate. Refer to
Instrument Panel Accessory Trim Plate Replacement
in Instrument
Panel, Gages and Console.
- Install the lower closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement
in Instrument Panel, Gages and Console.
- Install the center console. Refer to
Console Replacement
in Instrument Panel, Gages and Console.