The body control module (BCM) receives a ground signal from the door jamb, liftglass/liftgate, or courtesy lamp switches requesting courtesy/dome lamp illumination. When this occurs, the BCM directly sends a voltage through the courtesy lamp supply voltage circuit illuminating the courtesy/dome lamps.
The battery voltage must be between 9.0-16.0 volts.
• | When the BCM receives a courtesy lamp illumination request signal and the courtesy lamp supply voltage circuit is shorted to ground. |
• | When the BCM is not receiving a courtesy lamp illumination request signal and the courtesy lamp supply voltage circuit is shorted to voltage or open only to the first splice from the BCM. |
• | There is a loss of the rear fuse block TBC 3 battery supply voltage to the BCM for more than 1 second. |
The courtesy /dome lamps will not operate or are always on.
• | This DTC will clear on current status after the condition for setting the fault is corrected. |
• | A history DTC will clear after 100 consecutive ignition cycles without a fault present. |
• | History and current DTC(s) can be cleared using a scan tool. |
• | Perform a visual inspection for loose or poor connections at all related components. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. |
• | Only an open circuit up to the first splice from the BCM will set DTC B2615. |
The numbers below refer to the step numbers on the diagnostic table.
This step test determines if the problem exists in the wiring.
This step test determines if an open exists in the body wiring harness extension harness.
After replacement of the BCM you must calibrate the new module for proper operation.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Interior Lights Schematics | |||
1 | Did you perform the Lighting System Diagnostic System Check? | Go to Step 2 | |
Test the courtesy lamps supply voltage circuit for an open, high resistance, short to voltage, or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 8 | Go to Step 3 | |
Test the TBC 3 battery positive supply voltage circuit within the body wiring harness extension harness for continuity. Refer to Circuit Testing in Wiring Systems. Is continuity present? | Go to Step 4 | Go to Step 5 | |
4 | Inspect for poor connections at the harness connectors of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 8 | Go to Step 7 |
5 | Inspect for poor connections at the body wiring harness extension harness connectors. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 8 | Go to Step 6 |
6 | Replace the body wiring harness extension harness to the BCM. Refer to Body Control Module Body Wiring Harness Extension Harness Replacement in Body Control System. Did you complete the replacement? | Go to Step 8 | -- |
Important: Perform the setup procedure for the BCM. Replace the body control module (BCM). Refer to Body Control Module Replacement in Body Control System. Did you complete the replacement? | Go to Step 8 | -- | |
8 |
Does the DTC reset? | Go to Step 2 | System OK |