GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2003 🢒 Ascender - 4WD 🢒 Body and Accessories 🢒 Instrument Panel, Gages, and Console 🢒 Driver Knee Bolster Panel Replacement

Removal Procedure
  1. Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .

    2. Object Number: 712827 Size: SH
  2. Remove the 4 trim panel retaining screws.
  3. Release the clips that retain the trim panel to the IP.
  4. Remove the trim panel from the IP.

Installation Procedure

    Object Number: 712827 Size: SH
  1. Position the trim panel to the IP.
  2. Seat the clips that retain the trim panel to the IP.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the 4 trim panel retaining screws.

    4. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  4. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .