GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2003 🢒 Ascender - 4WD 🢒 Body and Accessories 🢒 Stationary Windows 🢒 Weatherstrip Side Retainer Replacement

Removal Procedure

    Object Number: 588275 Size: SH
  1. Open the front door.

    2. Remove the push pin retainers (2) from the front door sealing weatherstrip located at the base of the pillar.


    Object Number: 441415 Size: SH
  2. Pull back the front door sealing weatherstrip (1) in order to expose the weatherstrip side retainer screws (2).

    3. Object Number: 301107 Size: SH
  3. Remove the screws from the weatherstrip side retainer.
  4. Remove the weatherstrip side retainer from the windshield pillar.

Installation Procedure

    Object Number: 441415 Size: SH
  1. Install the weatherstrip side retainer (2) to the windshield pillar.

    2. Object Number: 301107 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the screws to the weatherstrip side retainer.

    3. Tighten
    Tighten the screws to the weatherstrip side retainer to 2 N·m (18 lb in).


    Object Number: 588275 Size: SH
  3. Install the push pin retainers (2) to the front door sealing weatherstrip located at the base of the pillar.
  4. Close the door.