GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2003 🢒 Ascender - 4WD 🢒 Body and Accessories 🢒 Bumpers 🢒 Front Tow Hook Replacement

Removal Procedure
  1. Remove the grille. Refer to Grille Replacement in Exterior Trim.
  2. Remove the front fascia. Refer to Front Bumper Fascia Replacement in Bumpers.
  3. Remove the front impact bar. Refer to Front Bumper Impact Bar Replacement in Bumpers.
  4. Place the impact bar on a clean, prepared surface.

    5. Object Number: 742128 Size: SH
  5. Remove the bolt that retains the tow hook to the impact bar.
  6. Remove the tow hook from the impact bar.

Installation Procedure

    Object Number: 742128 Size: SH
  1. Install the tow hook to the impact bar, ensuring that the locating pin is properly indexed to the impact bar.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolt which retains the tow hook to the impact bar.

    3. Tighten
    Tighten the bolt to 50 N·m (37 lb ft).

  3. Install the impact bar. Refer to Front Bumper Impact Bar Replacement in Bumpers.
  4. Install the fascia. Refer to Front Bumper Fascia Replacement in Bumpers.
  5. Install the grille. Refer to Grille Replacement in Exterior Trim.