Rear Bumper Step Pad Replacement Center

Notice: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.

1. Apply protective tape to bumper surface at the edge of the step pad.
2. Open the liftgate.



3. Use a flat bladed tool to release the step pad from the adhesive strips located at each end of the step pad.



4. Release the step pad retaining tabs.
5. Remove the step pad from the fascia.
6. Remove all adhesive from the rear door body panel using 3M™ ScotchBrite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
7. Clean the rear door panel surface using Varnish Makers and Painters (VMP) naphtha and allow to air dry.

1. Remove the backing from the adhesive strips.
2. Position the step pad to the fascia.
3. Install the step pad to the fascia, ensuring that the retaining tabs are thoroughly engaged, and the end of the step pad are secured.
4. Close the liftgate.