GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2003 🢒 Ascender - 4WD 🢒 Preface 🢒 Cautions and Notices 🢒 Console Replacement

Removal Procedure
  1. Block the wheels to prevent the vehicle from moving.
  2. Remove the rubber ash tray inserts and rubber mat from the console.
  3. Remove the floor shift control knob. Refer to Floor Shift Control Knob Replacement in Automatic Transmission.
  4. Remove the console storage compartment. Refer to Front Floor Console Compartment Replacement .

    5. Object Number: 741613 Size: SH
  5. Remove the center console retaining screws.
  6. Adjust the parking brake to the full-up, or fully engaged position.
  7. Slide the console rearward and raise the rear of the console in order to expose the electrical connectors.
  8. Disconnect the electrical connectors as necessary.
  9. Adjust the parking brake to approximately the halfway position.
  10. Remove the center console from the vehicle.

Installation Procedure

    Object Number: 741613 Size: SH
  1. Position the center console to the vehicle.
  2. Adjust the parking brake to the full-up, or fully engaged position.
  3. Connect the electrical connectors as necessary.
  4. Lower the rear of the console and slide the console forward into position.

    5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the center console retaining screws.

    6. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  6. Install the console storage compartment. Refer to Front Floor Console Compartment Replacement .
  7. Install the floor shift control knob. Refer to Floor Shift Control Knob Replacement in Automatic Transmission.
  8. Install the rubber ash tray inserts and rubber mat to the console.
  9. Remove the bocks from the vehicle.