GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 731580  Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Raise and support the rear axle at the designed D - height. Refer to Trim Height Specifications in Suspension General Diagnosis.
  3. Remove the rear axle lower control arm to the axle mounting nut and bolt.

  4. Object Number: 731582  Size: SH
  5. Remove the rear axle lower control arm to the frame mounting nut and bolt.
  6. Remove the lower control arm.

Installation Procedure


    Object Number: 731582  Size: SH
  1. Install the lower control arm.
  2. Install the rear axle lower control arm to the frame mounting nut and bolt.

  3. Object Number: 731580  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the rear axle lower control arm to the axle mounting bolt and nut.
  5. Tighten
    Tighten the lower control arm mounting bolts to 100 N·m (74 lb ft).

  6. Remove the rear axle support.
  7. Lower the vehicle.