GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 731617  Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Raise and support the rear axle at the designed D - height. Refer to Trim Height Specifications in Suspension General Diagnosis.
  3. Remove the rear axle tie rod to the axle mounting bolt and nut.

  4. Object Number: 731614  Size: SH
  5. Remove the rear axle tie rod to frame mounting bolt and nut.
  6. Remove the rear axle tie rod from the vehicle.

Installation Procedure


    Object Number: 731614  Size: SH

    Important: When installing the rear axle tie rod the bushings inner sleeve off set (largest gap) is towards the rear axle.

  1. Install the rear axle tie rod to the vehicle.
  2. Install the rear axle tie rod to frame mounting bolt and nut.

  3. Object Number: 731617  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the rear axle tie rod to the axle mounting bolt and nut.
  5. Tighten
    Tighten the rear axle tie rod mounting bolts to 195 N·m (144 lb ft).

  6. Remove the rear axle support.
  7. Lower the vehicle.