GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2005 🢒 Ascender - 4WD 🢒 Body 🢒 Seats 🢒 Rear Seat Cushion Replacement

Removal Procedure
  1. Remove the rear seat bracket trim cover.
  2. Remove the hydraulic jack from the jack stowage area, on the left side only.

    3. Object Number: 722615 Size: SH
  3. Position the seat cushion assembly in order to gain access to the 2 rear seat mounting nuts.
  4. Remove the 2 mounting nuts.
  5. Remove the seat cushion assembly from the vehicle.

Installation Procedure

    Object Number: 722615 Size: SH
  1. Position the seat cushion assembly to the vehicle.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the 2 nuts that retain the seat cushion assembly to the floor panel.

    3. Tighten
    Tighten the rear seat mounting nuts to 45 N·m (33 lb ft).

  3. Install the hydraulic jack into the jack stowage area, on the left side only.
  4. Adjust the seat cushion assembly to the latched position.
  5. Install the rear mount trim cover.