GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2005 🢒 Ascender - 4WD 🢒 Accessories 🢒 Garage Door Opener 🢒 Garage Door Opener Transmitter Replacement

Removal Procedure

    Object Number: 741633 Size: SH
  1. Remove the overhead console. Refer to Roof Console Replacement.
  2. Disconnect the electrical connector from the garage door opener (3).
  3. Remove the 3 retaining screws from the garage door opener.
  4. Remove the garage door opener from the overhead console.
  5. Remove the button assembly from the overhead console.

Installation Procedure

    Object Number: 754989 Size: SH
  1. Install the button assembly to the overhead console.
  2. Install the garage door opener to the overhead console. Fully recess the light indicator into the opening (1).

    3. Object Number: 741633 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the 3 retaining screws to the garage door opener.

    4. Tighten
    Tighten the screws to 0.8 N·m (7 lb in).

  4. Connect the electrical connector to the garage door opener (3).
  5. Install the overhead console. Refer to Roof Console Replacement.
  6. Refer to Control Module References for programming and setup information.