Tools Required

Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

1. Open the endgate window.



2. Remove the upper rear roof applique. Refer to Roof Rear Applique Replacement.




Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

Important: Keep the cutting edge of the tool against the window. Do this from inside the vehicle.

3. This will allow the urethane adhesive to be separated from the window.

•	Leave a base of urethane on the pinch-weld flange.

•	The only suitable lubrication is clear water.

•	Use J 39032 or equivalent in order to remove the window.




4. With the aid of an assistant, remove the quarter window (3) from the opening.

1. Install the body side stationary window (3) into the opening. Refer to Adhesive Installation of Bodyside Stationary Windows .
2. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.



3. Install the upper rear roof applique. Refer to Roof Rear Applique Replacement.
4. Inspect the radio or the OnStar® system, if equipped, to verify reception.
5. Close the endgate window.