GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2007 🢒 Ascender - 4WD 🢒 Body Systems 🢒 Vehicle Access 🢒 Door Inside Handle Replacement

Removal Procedure
  1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement or Rear Side Door Trim Panel Replacement .

    2. Object Number: 723027 Size: SH
  2. Remove the handle retaining bolt.
  3. Release the handle locator tab from the locator cutout, by sliding the handle forward.
  4. Release the rod retainer locks.
  5. Remove the rods from the handle.
  6. Remove the handle from the door.

Installation Procedure

    Object Number: 723027 Size: SH
  1. Position the handle to the door.
  2. Install the rods to the handle.
  3. Install the rod retainer locks.
  4. Insert the handle locator tab into the locator cutout and move the handle rearward, indexing the fastener hole to the door.

    5. Notice: Refer to Fastener Notice in the Preface section.

  5. Install the handle retaining bolt.

    6. Tighten
    Tighten bolt to 10 N·m (88 lb in).

  6. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement or Rear Side Door Trim Panel Replacement .